Mustang / T Bird rack to GM pump

By A Mystery Man Writer

Last updated 20 Jul 2024

Power Steering Hose Kits ford rack to GM pump 1 piece cast aluminum rack

Complete your power steering setup with out Mustang II to GM Pump Powering Steering Hose Kit while saving valuable time and money Features a 1974-78

1974-78 Fits Mustang II/74-80 Pinto Power Steering to GM Pump Hose Kit

Mustang II Power Steering 9/16-18 & 5/8-18 Power Rack AN Fittings Rat Hot Rod

Mustang II Power Steering Rack & Pinion w/ Offset Bushings, 82-88 T-bird Design, AN-6 Fittings, 3/4-36 Spline Input, Compatible with Original & Aftermarket Crossmembers, 15:1 Ratio

These stainless steel braided power steering hose kits will connect 1984-88 T-Bird and 1979-93 Mustang racks to most Ford or GM style internal reservoir power steering pumps. The hoses provide a custom look without the need to buy any additional parts. This kit is designed for drivers side pumps and may require hoses to be trimmed to length. Note: This hose kit is NOT applicable to the OEM 1974-1978 Mustang II power rack assembly that utilizes inverted flare fittings.

Gotta Show 131101 Mustang/T-Bird Rack & Pinion Power Steering Hose Kit

All-new using premium internals/seals, this is NOT a remanufactured assembly. 15-1/2-inch center-to-center mounting works with aftermarket crossmembers. Works with original 16-inch center-to-center Mustang II crossmembers using included offset rack bushings. Offset rack bushings are not used to raise or lower the rack, but to change mounting point center distance. Includes inner tie rods with SAE 9/16-18 threads installed with jam nuts.

Power Steering Rack & Pinion w/ Offset Mount Bushings, Fits Mustang II, Size: Small

L S GM, Power Steering Pump to Mustang Rack & Pinion steering system

Our standard power steering hose assemblies are an inexpensive alternative to the more costly stainless steel braided hose kits. This set adapts an

Speedway Motors 1982-88 T-Bird Steering Rack to GM Pump Power Steering Hose Kit with Adapters, 5/8'-18 Inverted Flare Pump End, Suitable for

This bracket fits the 2018-2023 Mustang with the performance pack, 2018-2023 California Special and 2019-2021 GT Bullitt. Constructed of 5052 and 6061 aluminum, welded and anodized black, this bracket is built to last. All parts required for installation included, however, tools are required. Requires 1 hole to be drilled on the underside of the vehicle. This hole is not visible and does not detract from the look of the vehicle. Made in USA.